Goodman 2 Ton 60 MBTU/H 13.4 SEER2 Packaged Dual Fuel, 208/230 Volt, GPDM32406041

• Model: GPDM32406041
• Cooling BTUH (Total): 23,800 BTU
• Cooling BTUH (Sensible): 19,275 BTU
• Cooling SEER2 / EER2: 13.4 / 10.6
• Voltage/Phase (60 Hz): 208/230-1

Standard Features

• Combines cooling with heat pump and gas heating for optimal year-long performance
• Energy-efficient scroll compressor
• Heavy-duty aluminized-steel heat exchanger
• Multi-speed ECM indoor blower motor
• All-aluminum evaporator coil
• Two-stage gas valve; natural gas with easy conversion to propane with accessory kit
• Power-assisted combustion
• High and low-pressure switch protection
• Direct spark ignition system includes a microprocessor-based control for the entire ignition sequence
• All blower operation and all safety circuits complete with self-diagnostics
• All models comply with California Low NOx emission standards
• This furnace does not comply with the SCAQMD Rule 1111 nor the SJVAPCD Rule 4905 14 ng/J NOx emission limit and therefore is not eligible for installation in California’s South Coast Air Quality Management District (SCAQMD) nor the San Joaquin Valley Air Pollution Control District (SJVAPCD)
• AHRI Certified; ETL Listed

Cabinet Features

• Fully insulated heavy-gauge, zinc-coated steel cabinet with UV-resistant powder-paint finish
• Louvered metal panel condenser coil protection
• Aluminum foil-facing internal insulation reinforced with fiberglass scrim
• Compressor sound blanket
• Convenient access panels
• One roof curb fits all units
• Bottom, 2” high base rails for easier handling
• All models fit a standard-size pick-up truck
• When properly anchored, meets the 2020 Florida Building Code unit integrity requirements for hurricane-type winds (Anchor bracket kits available.)
• Meets cabinet air leakage requirements when tested in accordance with ASHRAE standard 19
• One footprint for all tonnages

Cooling Capacity

• Total BTU/h: 23,800
• Sensible BTU/h: 19,275
• SEER2 / EER2: 13.4 / 10.6
• Decibels: 76
• AHRI Numbers: 209319576

Heating Capacity

• Heating Capacity, BTU/hr (47°F / 17°F): 23,500 / 13,900
• C.O.P. (47°F / 17°F): 3.30 / 2.30
• HSPF2: 6.7

Gas Heating

• High-Fire Input/Output (BTU/hr): 60,000 / 48,600
• Low-Fire Input/Output (BTU/hr): 45,000 / 36,450
• AFUE (%): 81
• Temperature Rise Range (°F): 25 - 55/25-55
• # of Burners: 3
• Primary/Auxiliary Limit Setting (°F): 150/150
• Roll-out Limit Setting (°F): 300

Evaporator Motor

• Type: ECM
• Wheel (D x W): 10" x 8"
• Indoor Nominal CFM: 800
• No. of Speeds: 5
• Motor Horsepower / FLA: 1/2 / 3.8
• Motor Speed Tap (Cooling and Heat Pump): T4
• Nominal CFM (Cooling and Heat Pump): 850

Evaporator Coil

• Face Area (ft): 4.35
• Rows Deep/Fins per Inc: 3/14
• Expansion Device (Orifice Diameter in.): 0.059
• Filter Size (ft): 2.7
• Drain Size (NPT): 3/4
• Refrigerant Charge - R-410A (oz): 108

Condenser Coil

• Face Area (ft): 12.2
• # Rows / Fins per Inch: 2 / 16
• Expansion Device (Orifice Diameter in.: 0.045

Condenser Motor / Fan

• Fan Diameter / # of Blades: 21.86" / 3
• Outdoor Nominal CFM: 2,200
• Motor Horsepower - RPM: 1/6 - 810
• Motor FLA: 0.95

Compressor

• Type: Scroll
• Stage: Single
• Run Load Amps / Locked Rotor Amps: 12.8 / 58.3

Electrical Data

• Voltage-Phase (Frequency 60Hz): 208/230-1
• Min. Circuit Ampacity: 20.8
• Maximum Overcurrent Protection: 30
• Entrance Size Power Supply: 1 1/8
• Entrance Size Control Voltage: 7/8

Weights & Dimensions

• Product Height (in.): 42 - 3/4 in
• Product Width (in.): 47 in
• Product Depth (in.): 51 in
• Operating Weight (lbs.): 420 lbs
• Shipping Weight (lbs.): 440 lbs

• Product Specs
• Limited Warranty (ONLY VALID IF INSTALLATION DONE BY LICENSED CONTRACTOR)

• 10 Years Parts Limited Warranty (ONLY VALID IF INSTALLATION DONE BY LICENSED CONTRACTOR)
• 20 Year Heat Exchanger Limited Warranty (ONLY VALID IF INSTALLATION DONE BY LICENSED CONTRACTOR)